U***J
发帖数: 5998 | 1 卸轮子的时候没觉得特使劲，结果一个stud就断了。到马自达dealer一套螺栓要17刀，
觉得贵的有点不讲道理。到NAPA一问，一套不到4刀。买入。准备这个周末干活儿。从
来没换过这个，看起来应该很容易。就怕锈在里面，敲不出来。 |
a***m
发帖数: 23 | 2 我换过尼桑的…WD40一噴，大锤猛砸，破的就出来了
新的放进去不大容易，先放冰箱冻一下，再从后面伸过来，前面用两个大螺丝加俩垫圈
拉紧 |
U***J
发帖数: 5998 | 3
Good idea. I will give it a try. Should be fun.
【在 a***m 的大作中提到】
: 我换过尼桑的…WD40一噴，大锤猛砸，破的就出来了
: 新的放进去不大容易，先放冰箱冻一下，再从后面伸过来，前面用两个大螺丝加俩垫圈
: 拉紧
|
U***J
发帖数: 5998 | 4
Spend less than 30min to fix the stud tonight. How do I post pictures here?
【在 U***J 的大作中提到】
:
: Good idea. I will give it a try. Should be fun.
|
U***J
发帖数: 5998 | 5
Remove the break first, than take off the break rotor. You do need a big
hammer to knock the broken stud out. But the new stud was too long to get
into the hole. I have to bend the break shield plate a bit to make that
happen. The stud was pulled into position with the nut. The rest is simply
put everything back in place.
The stud is $1.99, the nut is $1.19. Fixing this by myself, priceless. LOL.
【在 U***J 的大作中提到】
:
: Spend less than 30min to fix the stud tonight. How do I post pictures here?
|
w******x
发帖数: 4396 | 6 you could have just pushed the broken stud out with a gear puller.
【在 U***J 的大作中提到】
:
: Remove the break first, than take off the break rotor. You do need a big
: hammer to knock the broken stud out. But the new stud was too long to get
: into the hole. I have to bend the break shield plate a bit to make that
: happen. The stud was pulled into position with the nut. The rest is simply
: put everything back in place.
: The stud is $1.99, the nut is $1.19. Fixing this by myself, priceless. LOL.
|
