l******n
发帖数: 17 | 1 I cannot bear it any more, the disk load indicator
is always very high(about 95%) when I use JBuilder3.5.
The CPU load is ok, usually at 5~10%. It seems it's
always busy reading and writing the disk. I don't know
why...Guru here, it's that because sth like "swap"
config? where should I check? This is a new SUN Ultra 5
with 128M RAM. The disk space has about 3G left yet.
The disk r/w makes the system extremely slow! Even
when I switch between netscape windows, it takes about
15 seconds to redraw | t*******g
发帖数: 89 | 2 That must be something wrong.
use df -k to make sure that no partition is almost full.
you may use iostat and sar to check disk perfermance.
And swap partition should be around 256MB.
【在 l******n 的大作中提到】
: I cannot bear it any more, the disk load indicator
: is always very high(about 95%) when I use JBuilder3.5.
: The CPU load is ok, usually at 5~10%. It seems it's
: always busy reading and writing the disk. I don't know
: why...Guru here, it's that because sth like "swap"
: config? where should I check? This is a new SUN Ultra 5
: with 128M RAM. The disk space has about 3G left yet.
: The disk r/w makes the system extremely slow! Even
: when I switch between netscape windows, it takes about
: 15 seconds to redraw
|
|
