s*******n
发帖数: 12995 | 1 这些是约定俗成的佩枪方式的术语：
Condition 0 - A round is in the chamber, hammer cocked, and the safety is
off.
Condition 1 - furthermore known as "cocked and locked”, means a round is in
the chamber, the hammer cocked, and the manual thumb safety on the side of
the frame is applied.
Condition 2 - A round is in the chamber and the hammer is down.
Condition 3 - The chamber is empty and hammer down with a charged magazine
in the gun.
Condition 4 - The chamber is empty, hammer down and no magazine is in the
gun. | a***a
发帖数: 8941 | 2 I prefer condition 2, but it did not say the status of the safety
I think those conditions are according to 1911, right? | s*******n
发帖数: 12995 | 3 嗯。看上去是以1911为对象的。
不知道decork 算不算condition 2. 在SA的枪里，condition 2是没发击发的，但
decork的DA是可以击发的，只要力量足够。
1911，我是condition 1， P7，应该类似condition 2.
【在 a***a 的大作中提到】
: I prefer condition 2, but it did not say the status of the safety
: I think those conditions are according to 1911, right?
| b*******y
发帖数: 4304 | 4 本班的问题不是大家搞不清， 是大家都很纠结
in
of
【在 s*******n 的大作中提到】
: 这些是约定俗成的佩枪方式的术语：
: Condition 0 - A round is in the chamber, hammer cocked, and the safety is
: off.
: Condition 1 - furthermore known as "cocked and locked”, means a round is in
: the chamber, the hammer cocked, and the manual thumb safety on the side of
: the frame is applied.
: Condition 2 - A round is in the chamber and the hammer is down.
: Condition 3 - The chamber is empty and hammer down with a charged magazine
: in the gun.
: Condition 4 - The chamber is empty, hammer down and no magazine is in the
| d**********t
发帖数: 1821 | | s*******n
发帖数: 12995 | 6 左轮不用讨论。拔左轮的时候临时装子弹？
【在 d**********t 的大作中提到】
: 左轮咋算
|
|
