I********w 发帖数: 86 | 1 I don't quite understand the solution frequency in HFSS setting.
What kind of solution does HFSS get at this single frequency? S parameter?
How could it use a single frequency solution to get a result over a
frequency range?
Thanks for your input. |
z*****n 发帖数: 7639 | 2 Improvement of SNR.
【在 I********w 的大作中提到】 : I don't quite understand the solution frequency in HFSS setting. : What kind of solution does HFSS get at this single frequency? S parameter? : How could it use a single frequency solution to get a result over a : frequency range? : Thanks for your input.
|
G***T 发帖数: 66 | 3 1. solution frequency decides wavelength therefore determine the initial
mesh size and total meshs in the simulation. What happened in HFSS is based
on your solution frequency, HFSS will generate a initial solution, which
includes the mesh, port solution and etc. based on that frequency.
2. After the inital solution, HFSS will automatically refine the mesh and
perform a full solution until convergence based on that single solution
frequency.
3. If your model can be convergented at your solution |
t******a 发帖数: 151 | 4 when you set up the solution frequency, add a sweep into it. here you can se
t your frequency range.
it will give you sparameters, field plot in your frequency range. add infini
te sphere in radiation, then you can check antenna parameters.
I don't quite understand the solution frequency in HFSS setting.
What kind of solution does HFSS get at this single frequency? S parameter?
How could it use a single frequency solution to get a result over a
frequency range?
Thanks for your input.
【在 I********w 的大作中提到】 : I don't quite understand the solution frequency in HFSS setting. : What kind of solution does HFSS get at this single frequency? S parameter? : How could it use a single frequency solution to get a result over a : frequency range? : Thanks for your input.
|