88'camry V6 Driver side CV-BOOT DIY:
REMOVAL
1. loosen Axle hub Nut ( A 137 ft-lb Nut, breaker bar of course ) ( see break
it pic ).
2. loosen 5 lug nuts ( 76 ft-lb Nut )
3. Jack car safely and remove driver side wheel.( see three points jack pic )
4. Loosen the six nuts holding the driveshaft to the differential side gear
shaft
( six 48 ft-lb hex screws )
5. Separate the steering knuckle from the lower ball joint.
( Two 83 ft-lb Nuts )
6. Disconnect the tie rod end from the steering knuck