r******t
发帖数: 8967 | | r******t
发帖数: 8967 | | M*****0
发帖数: 1061 | | r******t
发帖数: 8967 | 4 没那么好做的吧。你会你说说？
至少上次我问ＣＯＭＳＯＬ的那个老印推销员他是没搞清楚。Solidwork里的那个模型是靠预设表格的，也等于白干。ＡＮＳＹＳ ＭＵＬＩＴＩＰＨＹＳＩＣＳ里到是有例子，可惜我没这个软件。
【在 M*****0 的大作中提到】
: +2
: 现在小孩真TMD的懒
| i****a
发帖数: 88 | 5 You can use any software, like ANSYS or Icepak or other softwares for 2/3-D
problem.
There are two ways to model TEC cooler module:
(1) Use ANSYS thermoelectric element, but it is only suitable for a single
pellet element device modeling.
(2) Using an equivalent temperature-dependent heat source at cold and hot
sides to model the thermoelectric effect. If you want to determine the
electric current need to maintain certain cold side temperature, have to use
iteration method, to get the desired I. |
|
