c********m 发帖数: 571 | 1 可能是个傻瓜问题。
是不是可以把盘在spool里的线松出一段,把外面不好用的剪掉就可以了?直到剩下的
不多再重新换?
谢谢! |
x******g 发帖数: 3952 | 2 大部分的trimmer线都会自己出的呀。不用手动松。
【在 c********m 的大作中提到】 : 可能是个傻瓜问题。 : 是不是可以把盘在spool里的线松出一段,把外面不好用的剪掉就可以了?直到剩下的 : 不多再重新换? : 谢谢!
|
c********m 发帖数: 571 | 3 Thanks for answering my questions. :-)
Just read the manual again. Found it will advance line when tapping the
header bottom to the ground. I will try it out.
Once the line is advanced, will it be automatically to be cut into
appropriate length?
【在 x******g 的大作中提到】 : 大部分的trimmer线都会自己出的呀。不用手动松。
|
x******g 发帖数: 3952 | 4 线是一点一点出的。不会一下变很长的。
【在 c********m 的大作中提到】 : Thanks for answering my questions. :-) : Just read the manual again. Found it will advance line when tapping the : header bottom to the ground. I will try it out. : Once the line is advanced, will it be automatically to be cut into : appropriate length?
|
w*****g 发帖数: 3922 | 5 借帖问个trimmer线的问题。我新买的线用的特别快,基本上一次就用光所有已经绕在
上面的线了。请问这是为什么?是线的质量太差?还是我绕的方法不对(我装上之后,
是拉不动两根线的)?
【在 c********m 的大作中提到】 : 可能是个傻瓜问题。 : 是不是可以把盘在spool里的线松出一段,把外面不好用的剪掉就可以了?直到剩下的 : 不多再重新换? : 谢谢!
|