m*d
发帖数: 745 | 1 case经过 resize, 是火药少的原因么？ |
h*******g
发帖数: 2201 | 2 It's quite possible. If the gas pressure is too low due to lack of gun
powder burning, it will not have enough momentum to drive back the slide and
recock the hammer.
But this can also happen if you do not have good lubricant on the slide rail
, as said in the FAQ on sig website. However this is quite unlikely, and can
be tested by trying with a quality ammo. |
m*d
发帖数: 745 | 3 打S&B的弹没问题，应该不是rail的问题。再网上看了看，怎么有人说太hot了也会造成
cycling的问题。觉得这说法不太靠谱。
and
rail
can
【在 h*******g 的大作中提到】
: It's quite possible. If the gas pressure is too low due to lack of gun
: powder burning, it will not have enough momentum to drive back the slide and
: recock the hammer.
: But this can also happen if you do not have good lubricant on the slide rail
: , as said in the FAQ on sig website. However this is quite unlikely, and can
: be tested by trying with a quality ammo.
|
f*********n
发帖数: 11154 | 4 不能cycle是击发以后slide没有被完全推回来？用的什么火药，多少装药量？
【在 m*d 的大作中提到】
: case经过 resize, 是火药少的原因么？
|
m*d
发帖数: 745 | 5 用的是wst. 看来是装 药量少了点。 从3.7增加到4.1后，cycle就没有问题了。 但还
是有light strike的问题。有时候需要击发两次。
这和用的是winchester small pistol maganum primer有关么？
【在 f*********n 的大作中提到】
: 不能cycle是击发以后slide没有被完全推回来？用的什么火药，多少装药量？
|
m*d
发帖数: 745 | 6 case经过 resize, 是火药少的原因么？ |
h*******g
发帖数: 2201 | 7 It's quite possible. If the gas pressure is too low due to lack of gun
powder burning, it will not have enough momentum to drive back the slide and
recock the hammer.
But this can also happen if you do not have good lubricant on the slide rail
, as said in the FAQ on sig website. However this is quite unlikely, and can
be tested by trying with a quality ammo. |
m*d
发帖数: 745 | 8 打S&B的弹没问题，应该不是rail的问题。再网上看了看，怎么有人说太hot了也会造成
cycling的问题。觉得这说法不太靠谱。
and
rail
can
【在 h*******g 的大作中提到】
: It's quite possible. If the gas pressure is too low due to lack of gun
: powder burning, it will not have enough momentum to drive back the slide and
: recock the hammer.
: But this can also happen if you do not have good lubricant on the slide rail
: , as said in the FAQ on sig website. However this is quite unlikely, and can
: be tested by trying with a quality ammo.
|
f*********n
发帖数: 11154 | 9 不能cycle是击发以后slide没有被完全推回来？用的什么火药，多少装药量？
【在 m*d 的大作中提到】
: case经过 resize, 是火药少的原因么？
|
m*d
发帖数: 745 | 10 用的是wst. 看来是装 药量少了点。 从3.7增加到4.1后，cycle就没有问题了。 但还
是有light strike的问题。有时候需要击发两次。
这和用的是winchester small pistol maganum primer有关么？
【在 f*********n 的大作中提到】
: 不能cycle是击发以后slide没有被完全推回来？用的什么火药，多少装药量？
|
c****x
发帖数: 1270 | |
t**********e
发帖数: 1590 | 12
楼主为啥用mag primer？应该直接用small pistol primer。还有，弹药用量是需要有
根据的，然后再一点点摸索。
【在 m*d 的大作中提到】
: 用的是wst. 看来是装 药量少了点。 从3.7增加到4.1后，cycle就没有问题了。 但还
: 是有light strike的问题。有时候需要击发两次。
: 这和用的是winchester small pistol maganum primer有关么？
|
