h*****3 发帖数: 91 | 1 我用structure editor 先建立了一个简单的3d NMOS结构。然后用sentaurus device跑
仿真,可是每次都是:
Reading grid '1_msh.tdr' ... (TDR format) done.
(Number of grid points is 7261.)
Adding interfaces and contacts ...
Tried to use non-existing contact 'source' !
然后就不行了。
我在建立模型的时候明明有定义contact的。不知是什么原因,应该怎么办呢?
初学Sentaurus, 还请各位前辈指导阿。
感激不尽! |
g***i 发帖数: 795 | 2 Try to run your script within SDE line by line to dig out any warnings,
obviously you did not define your contact properly, or you can check your
structure in tecplot. The third way is looking into your TDR file directly. |
h*****3 发帖数: 91 | 3 thanks ls.
finally find the reason.
The name of electro-gate is changed antomatically.
In sentaurus structured editor I named the contact "gate", but in sentaurus
devices it was changed into "gate_11".
Why? |
h*****3 发帖数: 91 | 4 thanks ls.
finally find the reason.
The name of electro-gate is changed antomatically.
In sentaurus structured editor I named the contact "gate", but in sentaurus
devices it was changed into "gate_11".
Why? |