r******d 发帖数: 1879 | 1 老爷车开了15w迈了。最近出现了一些问题, 不知道自己能不能修
1 打火启动
2 行驶15分钟左右
3 踩刹车红灯停
4 绿灯,松刹车
5 轻踩油门, 不动
6 稍微加力,车突然向前冲一下
7 然后平稳
重复3-7
多谢多谢 |
p*****d 发帖数: 139 | 2 transmission
【在 r******d 的大作中提到】 : 老爷车开了15w迈了。最近出现了一些问题, 不知道自己能不能修 : 1 打火启动 : 2 行驶15分钟左右 : 3 踩刹车红灯停 : 4 绿灯,松刹车 : 5 轻踩油门, 不动 : 6 稍微加力,车突然向前冲一下 : 7 然后平稳 : 重复3-7 : 多谢多谢
|
r******d 发帖数: 1879 | 3 换 transmission oil 会有帮助吗? |
p*****d 发帖数: 139 | 4 多久没换了?稀了失去粘性 可能会换挡不顺
试试看吧
否则换一个transmission至少上千
【在 r******d 的大作中提到】 : 换 transmission oil 会有帮助吗?
|
r******d 发帖数: 1879 | |
p*****d 发帖数: 139 | 6 也不一定 也有可能就是你油门松 然后你用力踩急了 一下就出去了
【在 r******d 的大作中提到】 : 10w大修的时候可能换过。 你说的很有道理。
|
n****i 发帖数: 109 | 7 99% it is throttle body dirty.
go to walmart to buy a bottle of Throttle Body Cleaner(<$5), use a tooth
brush to clean TB(<10min). Then you will have smooth start.
Please send me a mail when you fix the problem.
It has nothing to do with tranny, don't go to any garage, they will charge
you a lot for it. |
v*******d 发帖数: 3525 | 8 最好去可靠的修车铺查一下吧
光靠论坛上讲不可靠
charge
【在 n****i 的大作中提到】 : 99% it is throttle body dirty. : go to walmart to buy a bottle of Throttle Body Cleaner(<$5), use a tooth : brush to clean TB(<10min). Then you will have smooth start. : Please send me a mail when you fix the problem. : It has nothing to do with tranny, don't go to any garage, they will charge : you a lot for it.
|
r******d 发帖数: 1879 | 9 If it is throttle body dirty, should the problem occur when I start the
engine, instead of after 15 mins driving? But I will do the cleaning as you
suggested.
【在 n****i 的大作中提到】 : 99% it is throttle body dirty. : go to walmart to buy a bottle of Throttle Body Cleaner(<$5), use a tooth : brush to clean TB(<10min). Then you will have smooth start. : Please send me a mail when you fix the problem. : It has nothing to do with tranny, don't go to any garage, they will charge : you a lot for it.
|
r******d 发帖数: 1879 | 10 自己先折腾折腾,反正修不好也修不坏
【在 v*******d 的大作中提到】 : 最好去可靠的修车铺查一下吧 : 光靠论坛上讲不可靠 : : charge
|
r******d 发帖数: 1879 | 11 very frustrated.
bought 9qt transimission fluid, jacked up the car, then found a square hole
looking like the outlet. I went through my toolbox and found nothing fit.
then I went to Pepboys got a square socket, and jacked up the car again,
then found my rachet can't fit into the narrow space. It is 9:00pm, climbing
out from the bottom of the car, wondering whether I should find a mechanic. |
P***5 发帖数: 1089 | 12 要买extention bar and/or u joint?
But the first thing is to find a procedure you can follow, where you'll find
what tools you need to use and how difficult the job is
hole
climbing
mechanic.
【在 r******d 的大作中提到】 : very frustrated. : bought 9qt transimission fluid, jacked up the car, then found a square hole : looking like the outlet. I went through my toolbox and found nothing fit. : then I went to Pepboys got a square socket, and jacked up the car again, : then found my rachet can't fit into the narrow space. It is 9:00pm, climbing : out from the bottom of the car, wondering whether I should find a mechanic.
|