t****t
发帖数: 610 | 1 I'm going to lay tiles at the entry. However, how do I handle the transition
between door threshold and the tile?
I have several ideas:
1. leave a small gap between tiles and existing door threshold. Then cover
the gap with a transition strip or reducer.
2. Remove door threshold. Lay tiles beneath and only extend into that area a
little bit. Then bend the inside part of the door threshold to fit tiles
and put it back.
3, Install a different type of door threshold that can handle different
height... 阅读全帖 |
|
|
H******7
发帖数: 34403 | 3 听了本版建议，买了garage door threshold，附送的硅胶是硬的，没法用，自己又高
价买了两筒硅胶密封胶。装上了，效果不错。但是..
这个一个月下来这thrshold就hold不住了，可能被车子压来压去，弹来弹去就松了。掀
开看，硅胶粘下面的地面还是粘得不错，但跟threshold就基本粘不住。何解？ |
|
m*******r
发帖数: 16 | 4 It can be called SOA below thrshold. But the fiber-to-fiber gain might be too small (cannot compensate your loss due to the fiber coupling etc). You coupling loss depends on your alignment, waveguide structure, fiber type etc, could be more than 6 dB easily.
AR coating should be about $1000 per run. |
|
